Help with Carb sync tool

[Batt5]

I have a Motion Pro Carburetor Synchronizer, it is brand new and old at the same time. It has in been in the box for a few 'years'. It appears complete along with a vile of mercury. It does not however have any instructions on how to install the mercury into it.

So does anyone out there know how the mercury is installed into the bright yellow vacuum tubes. Really the tubes are clear..

I sent an email to Motion Pro and have gotten no response. I do know that they do not sell the carb sync that used mercury anymore.

Any suggestions will be appreciated.

[Batt5]

http://d3jwipev4rb4cn.cloudfront.net...unner_tool.jpg


that is what it looks like....

[Batt5]

Got it..................

[inline4]

Or just invest in a Morgan CarbTune II. It is THE best carb synch tool I've ever used. No mercury, just aluminum rods.
I'm sure other Morgan fans will chime in here too.
Jim

[JeffS]

Got it..................

You got it working?

[frenchpc]

Try these links from their website:

http://www.motionpro.com/documents/p...5%20(rev6).pdf

http://www.motionpro.com/documents/p...2_I08-0411.pdf

http://www.motionpro.com/documents/p...id_CleanUp.pdf

[Mark]

Or just invest in a Morgan CarbTune II. It is THE best carb synch tool I've ever used. No mercury, just aluminum rods.
I'm sure other Morgan fans will chime in here too.
Jim

I prefer four oil-filled vacuum gauges with attached, stiff hosing, but that's just me.

[ramblin66]

If I was the OP, I would NOT use the Mercury.
I would order a refill kit that contained non-Mercury manometer fluid.

Contact your local waste disposal company or your city sanitation department to locate a local disposal facility for the Mercury.

http://www.amazon.com/Motion-Pro-Syn.../dp/B001AWK5XE

[NATURALBORNKILLAR]

I have an antique set of 4 vacuum gauges monted on a panel.... flutter adjustement and zero adjustment....
work brilliantly....purchased for my '74 Kaw 900 Z1 many moons ago............................................... ........grasshopper,,,,,,,,,,,,,,,,,.old farts invest in tools wisely

this is funny......went out to the garage tonite just for shites..


the 4 panel set says............Dixie Toll & Die Co.
Aurora, IL.


gauges say............. ...Marsh Instrument Co.

must have purchased it in the 1980's for about $60.00 which was a lot then.


still use it on the Zed
NBK

[Moise]

Definitely DO NOT use the mercury and dispose of it safely.